Hi
I'm new to the forum and I would like to know if someone has tried to use the TMM4 sensor from IDBike o the factory Tongsheng software or on another open source one, from what I understood there's severals!?
I also would like to know if someone could give me the center distance between the pinion and the bottom bracket shaft?
and finally but not least
If someone could help me measuring 3 tooth of the pinion on the tangent line (see attachment) so that I can know the module of the gear or simply giving the module of the gear if already known?
If this information already exists on the forum I apology!
I want to do a project but before commit myself to spend 500€ I want to know if it will work on my project!!
Thanks everyone
I'm new to the forum and I would like to know if someone has tried to use the TMM4 sensor from IDBike o the factory Tongsheng software or on another open source one, from what I understood there's severals!?
I also would like to know if someone could give me the center distance between the pinion and the bottom bracket shaft?
and finally but not least
If someone could help me measuring 3 tooth of the pinion on the tangent line (see attachment) so that I can know the module of the gear or simply giving the module of the gear if already known?
If this information already exists on the forum I apology!
I want to do a project but before commit myself to spend 500€ I want to know if it will work on my project!!
Thanks everyone