Those halls are along way from the mags !, you may have some problems once you start putting a load onto the motor but it will be very intresting to see how it goes.whereswally606 wrote:Just managed to get a 80/100 working with my 48v golden motor controller. This is my first video upload to the sphere and also to youtube.
The motor is from Leaderhobby and is the EMP not turnigy.
this took me most of the day to cobble together but pretty much struck lucky with the hall wire combinations hit a good combo on the second try.
hope to get it on my norco savage soon, currently looking into double freewheel acs southpaw system.
It will not be to much bother to make a mold for 59mm dia with the correct spacing. The hall sensors that I am using are far less sensitive than the 411 so less likely to be triggered early from energised poles also the spacing of the sensors are directly above a slot so this also minimises the likely hood of false triggering. I bought a starter resin casting kit, the moulds are silicon ( came with the kit ). The difficult bit was working out a way of holding the sensors in place until the resin set. I didnt take any pics making the mould but I took a pic of the first one I cast in the first mould I made: I have since remade this mould to make it easier to wire up and keep the sensors in place.HumboldtRc wrote:Do you think the 63mm spacing will work with the new sk3's? Because they are 59mm diameter even though they still call them 63-74... I need a bunch of them for my mountainboards. Can you make another mold for the 59mm motor's so they will be perfect? Can you post more info and pictures on how you made your molds and what materials you are using for the molds and the actual sensor cast material/resin? What is the difference in the sensors you are using compaired to the s411 sensors? Thanks
I have been playing around with a smaller version complete with mount, results are good, so these smaller versions will be available to buy should anyone want them, I have tested them on 63mm dia motors and on the larger 80mm dia motors. I need to make myself around 12 of these so I will be ordering the hall sensors soon. If anyone else would like one then please express your interest before I order my halls ( in a weeks time ). I will update the thread in the for sell section of the forum https://endless-sphere.com/forums/viewto ... 31&t=36149 .minuteman2k wrote:Gwhy
When will a kit be available??
Yhis is great for all RCers