Electric Motors and Controllers
- 10 mW
- Posts: 24
- Joined: Apr 29, 2016 2:22 pm
Lebowski wrote: ↑
Apr 14, 2018 5:55 am
Did the chip correctly find two temp sensors ? Does it display the two identification codes ?
Yes - the codes are there and the displayed values are increasing or decreasing in the right direction in 0.5 steps. I was just wondering about the high values...
- 1 GW
- Posts: 3200
- Joined: Jun 28, 2011 1:38 am
- Location: beautiful Zurich, Switzerland
Did you just solder them ? You should be getting the correct values... did you add the pull up resistor ?