Electric Motors and Controllers
kywalda 1 mW
- Posts: 19
- Joined: Apr 29 2016 2:22pm
Lebowski wrote: ↑
Apr 14 2018 5:55am
Did the chip correctly find two temp sensors ? Does it display the two identification codes ?
Yes - the codes are there and the displayed values are increasing or decreasing in the right direction in 0.5 steps. I was just wondering about the high values...
Lebowski 1 GW
- Posts: 3173
- Joined: Jun 28 2011 1:38am
- Location: beautiful Zurich, Switzerland
Did you just solder them ? You should be getting the correct values... did you add the pull up resistor ?