Please help me figure out wiring this Starglobe controller

Electric Motors and Controllers
Post Reply
Quinc   10 W

10 W
Posts: 93
Joined: Apr 18 2016 11:21am

Please help me figure out wiring this Starglobe controller

Post by Quinc » Nov 03 2017 4:13pm

Picked this up with a matching star globe motor a couple years ago and set them aside.. Now I am trying to use them for my 4 year olds gokart. But I either cannot figure out the wiring or it is dead.. Any help is much appreciated!

I am using a known working 3 pin throttle and 36v. I also tested the motor by hooking it up to my razor verifying it works.



I believe it is:
Green = Motor POS
Black = battery/motor NEG
Red = battery POS
Yellow = ?
brown/white = key switch?
red/green = charger?

Throttle is 5 pins:
blk/brn/wht/red/grn

Image
Image
Image

Quinc   10 W

10 W
Posts: 93
Joined: Apr 18 2016 11:21am

Re: Please help me figure out wiring this Starglobe controll

Post by Quinc » Nov 03 2017 6:54pm

I think I have the battery and motor setup correctly The two plug red/grn wires the red is putting out 37v. And on the throttle connector the red wire is putting out 5.7v. the big Yellow wire puts out .03v. None of the other throttle plugs put out anything.

User avatar
x.l.r.8   100 W

100 W
Posts: 111
Joined: Jul 30 2017 12:13pm
Location: Toronto and Cambridge

Re: Please help me figure out wiring this Starglobe controll

Post by x.l.r.8 » Nov 11 2017 10:40pm

the throttle may well be 3 throttle and 2 to make the brake or safety cut off when joined. yellow reverse?
the red and green, does the green have continuity with the black. on a lot of bikes I have seen of late the green is the negative wire. if so some aux circuit or the charging plug for the battery
Intelligence is distributed nearly evenly, with only the occasional concentration in one person. The total quantity of Intelligence is a constant: as more people come into being, fewer and fewer get a sufficient amount for themselves.
Some say this has already reached homeopathic levels.

User avatar
fechter   100 GW

100 GW
Posts: 12926
Joined: Dec 31 2006 3:23pm
Location: California Bay Area, USA

Re: Please help me figure out wiring this Starglobe controll

Post by fechter » Nov 11 2017 10:45pm

Usually the motor positive goes to the red wire (along with the battery +), motor negative to the green wire.
"One test is worth a thousand opinions"

Post Reply