I opened my MXUS v3 and noticed a small scrape on the varnish of the copper wire. I tested the continuity with my multimeter and it shows a short to my phase wires.
I'm not sure how it happened, it doesn't seem raised enough to be touching the side plate.
Is this a major problem or will this cause an issue?
Edit: changed the wording.
MXUS copper wire coating damaged
MXUS copper wire coating damaged
Last edited by shorza on Jan 02 2018 3:50pm, edited 1 time in total.
Re: MXUS lamination coating damaged
It appears, from photos, that you refer to a scrape or bare spot on the wire, not a damaged lamination. Laminations are thin steel plates stacked together to make the core. Coils of wire are wound or inserted onto or into slots in the laminated core. The coil wire is copper with a coating or film of insulating varnish or resin. A small bare spot like that on a single wire that does not come in contact with anything else is inconsequential although to be on the safe side, I'd recommend to repair by applying a drop or two of high temperature epoxy or 'super' glue.
major
major
Re: MXUS lamination coating damaged
Yes, epoxy will fix that, but you should not have any continuity between the phase wires and the laminations. You may have another problem somewhere.
"One test is worth a thousand opinions"
Re: MXUS copper wire coating damaged
Thanks guys. I've edited the original post to amend the incorrect term.
The laminations are not damaged, it's the coating on the copper wire that is damaged. I'll put a small dab of super glue over it like major suggested.
The laminations are not damaged, it's the coating on the copper wire that is damaged. I'll put a small dab of super glue over it like major suggested.
Re: MXUS copper wire coating damaged
just make sure its rated for higher temperatures - super glue can start to break down at ~80C - your wires may get much hotter than that.
My builds:
https://endless-sphere.com/forums/viewt ... 28&t=75782
Custom frame 12kw mid drive
http://endless-sphere.com/forums/viewto ... =3&t=29373
Norko Aline rv100pro
http://endless-sphere.com/forums/viewto ... 23#p534823
'02ish Avanti D8 - 8085 RC mid drive
http://endless-sphere.com/forums/viewto ... 12&t=43143
Electric mountainboard
http://endless-sphere.com/forums/viewto ... 35&t=57489
RC longboard/CNC'd parts
https://endless-sphere.com/forums/viewt ... 28&t=75782
Custom frame 12kw mid drive
http://endless-sphere.com/forums/viewto ... =3&t=29373
Norko Aline rv100pro
http://endless-sphere.com/forums/viewto ... 23#p534823
'02ish Avanti D8 - 8085 RC mid drive
http://endless-sphere.com/forums/viewto ... 12&t=43143
Electric mountainboard
http://endless-sphere.com/forums/viewto ... 35&t=57489
RC longboard/CNC'd parts