HBM3000

Aabdooo

1 µW
Joined
Apr 22, 2018
Messages
2
Hello :) ,

i bought BLDC motor HBM3000 and kely controller KLS6022H, and i tried to make the identification angle for the motor as mentioned in Kely controller manual, but every time give me the Hall error and identify error in the programmer user.

And the status of hall sensors A B C is 1 1 1 in the programmer user monitor.

So, can anyone help me please?
 

Attachments

  • unnamed.jpg
    unnamed.jpg
    2.5 KB · Views: 459
If all the hall sensors are reported as on at the same time, then there could be a connection problem to the halls in the motor (any of the 5 wires to them; power, ground, or signals).

Or the sensor could be defective.
 
Back
Top