Page 1 of 1

prius inverter gen 3 + toyota rear motor

Posted: Jul 09 2018 7:30pm
by Abricosvw
hi ...
i am from NJ ... ((if someone is nearby??))
my new project I want to run prius inverter gen 3 + toyota highlander rear motor ... ((homemade hybrid))
I want to install all this set on to 96 vw passat B4 on rear wheels ... ((at an early date))
I do not have much experience and no education but I have a lot of interest ...

my first steps i got highlander rear motor 50KW
on the video, I just test it works or not ((12V cheap chinese driver))
[youtube]https://youtu.be/xrGgDHG6X7w[/youtube]

Re: prius inverter gen 3 + toyota rear motor

Posted: Jul 09 2018 7:32pm
by Abricosvw
step two prius inverter gen 3 100KW
couple of photos
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image

Re: prius inverter gen 3 + toyota rear motor

Posted: Jul 09 2018 8:29pm
by Abricosvw
step three inverter connector + pigtail
pigtail from inverter connector is attached to fuse box
Image

Image
Image
Image
Image


I do not have connector from resolver encoder ((sensor))
Image
Image

Re: prius inverter gen 3 + toyota rear motor

Posted: Jul 09 2018 8:39pm
by Abricosvw
step four
we need to understand what kind of wires ((enter and exit to the inverter))
Image
Image
Image

if you pay attention to the blue electrical tape ...
there is a twist of wires and a change in the color coloration ...
Image

Re: prius inverter gen 3 + toyota rear motor

Posted: Jul 10 2018 8:22pm
by Abricosvw
Now we need to understand which connector ((who is who)) ...
Image
Image
New Bitmap Image (2).jpg
New Bitmap Image (2).jpg (145.12 KiB) Viewed 1197 times
New Bitmap Image.jpg
New Bitmap Image.jpg (149.64 KiB) Viewed 1197 times

Re: prius inverter gen 3 + toyota rear motor

Posted: Jul 10 2018 8:43pm
by Abricosvw
now the most important thing we need to understand how to control the inverter ...
we need a diagram and pinout from connector which on the side ((enters)) in inverter ...
in attached pdf file we are interested connectors D29 A59
Image
invertor diogram gen3.pdf
(1.04 MiB) Downloaded 98 times

Re: prius inverter gen 3 + toyota rear motor

Posted: Jul 30 2018 5:03pm
by Abricosvw
now we need to somehow manage the inverter ( driver ) ...
so that you can manage and change settings and customize how your electric motor should rotate and work ...
we need Electronic control unit ...
I chose Lebowski's motor control viewtopic.php?f=30&t=57877&hilit=Lebowski+Brain+board
in our option We only need Lebowski( chip brain ) ... and an expansion board ...
read the documentation how to manage the program download/file.php?id=108834
for windows 10 download Termite version 3.4 - complete setup https://www.compuphase.com/software_termite.htm
If you follow the instructions in the PDF file you will have same as in the photo below
Новый точечный рисунок.jpg
:mrgreen: note :mrgreen:
I had a few problems
the first as I understood my laptop does not have ground wire ... I started using a desktop PC the noise was gone ...
there was also a problem with cheap RS232 Serial Port from 5 different worked only one
IMAG0006.jpg