ecologymagnet
10 W
- Joined
- Jan 6, 2012
- Messages
- 82
I am passing an alternator to a brushless motor; but I have a series of problems:
1) Flashing when starting, I think I should put sensors, any ideas for it?
2) I doubt about the voltage of the internal rotor, I tried with 6v and 12v, recommend in some guides 5v and if it seems to work well to 6v; but this rotor demands very little intensity and I doubt if it would be better with greater power.
3) I doubt about the voltage of the three-phase coil, so I saw it works well at 18S LIPO and arrives easily at 30A which limits the controller.
4) The use will be to electrify a quad, I doubt how to adapt the pinion to the axle.
5) Is it viable ?, efficiency?
[youtube]cFE0rFiEjG0[/youtube]
1) Flashing when starting, I think I should put sensors, any ideas for it?
2) I doubt about the voltage of the internal rotor, I tried with 6v and 12v, recommend in some guides 5v and if it seems to work well to 6v; but this rotor demands very little intensity and I doubt if it would be better with greater power.
3) I doubt about the voltage of the three-phase coil, so I saw it works well at 18S LIPO and arrives easily at 30A which limits the controller.
4) The use will be to electrify a quad, I doubt how to adapt the pinion to the axle.
5) Is it viable ?, efficiency?
[youtube]cFE0rFiEjG0[/youtube]
