MXUS 3000 @ 24S and 30S LIPO 80A

Joined
Jan 6, 2012
Messages
82
I need a bms for 24s Lipo and peak 80A.

I also do not rule out buying a charger or charging them disconnected with my icharger.

The use is a battery for an ebike with a MXUS 3000 and a modified alternator in a Quad, both with a maximum controller 80A.

I have no screen in either of the two, so it would not hurt if it works by Bluetooth or implement screen.

Thank you very much!
 
I have tested my MXUS 3000 at 24S Lipo Nanotech 8000 and a Leo controller up to 80A and I have been very satisfied with a lot of acceleration and 80 Kms/h on level and 90 with lowering.

Now I think about putting 30S with 80A, which I think the Leo controller supports, will it support the motor acceptably?

Is there a power supply to power a 100V or 125V BMS with the battery fully charged?
 
Back
Top