Hi, I'm sorry if this thread already exist.
I have a no name chineese standard looking e bike controller rated at 48v - 30a bought from ebay with a hub kit.
I dont have any information except it is labeled ZHZ1000w, googling for datasheets or any info did not give any results.
I tried to wire it without hall connections to the motor but it does not spin so i am wondering if i could make this thing to work sensorless and how, because my halls keep dying, I already replaced 2 of them.
Do i have to jump some wires or make some hardware or firmware modifications?
Thanks.
I have a no name chineese standard looking e bike controller rated at 48v - 30a bought from ebay with a hub kit.
I dont have any information except it is labeled ZHZ1000w, googling for datasheets or any info did not give any results.
I tried to wire it without hall connections to the motor but it does not spin so i am wondering if i could make this thing to work sensorless and how, because my halls keep dying, I already replaced 2 of them.
Do i have to jump some wires or make some hardware or firmware modifications?
Thanks.