I just recently started with a project and am using Sevcon Gen4 DC.
I was able to communicate with the software interface with the controller and also able to solve all the fault warnings.
The last and only problem I have now is that the parametrization of the software doesn't work and I see
"Abort 0x08000000" literally everywhere.
For Ex: I goto Line Contactor Parameters and try to set the Pull-In Voltage to 24V and load value(preop)
As soon as I click on read value it goes back to "Abort 0x08000000"
Did anyone else have this same problem? When yes, how did you solve it?
Does anyone here have the knowledge to know what the problem would be?
I need urgent help on this topic!
Many thanks in advance
Electric Motors and Controllers
2 posts • Page 1 of 1