Dear electric car friends!
I want to run a stripped Zytek IDT 120-55 motor with a Sevcon controller. I have removed the complete original control unit and only want to use the short motor. As motor encoder I installed a SKF sensor bearing, which generates a square wave signal and delivers 64 pulses per revolution. Unfortunately Zytek is not very helpful with the missing motor data. For this reason it is unfortunately not possible for me to make the motor turn.
Now my question is to you:
1.) Has someone perhaps the necessary motor data for programming or
2.) Can someone provide me with SCWizard from Sevcon? In the current DVT version there is no function for Self Configuration anymore.
I would be very grateful for your help.
Best regards
Volkmar
Austria
Top
I want to run a stripped Zytek IDT 120-55 motor with a Sevcon controller. I have removed the complete original control unit and only want to use the short motor. As motor encoder I installed a SKF sensor bearing, which generates a square wave signal and delivers 64 pulses per revolution. Unfortunately Zytek is not very helpful with the missing motor data. For this reason it is unfortunately not possible for me to make the motor turn.
Now my question is to you:
1.) Has someone perhaps the necessary motor data for programming or
2.) Can someone provide me with SCWizard from Sevcon? In the current DVT version there is no function for Self Configuration anymore.
I would be very grateful for your help.
Best regards
Volkmar
Austria
Top