Forklift DC hydro-pump motor viability for EV application?

k2nguru

10 mW
Joined
Jun 22, 2014
Messages
25
Location
Tallinn
Has anybody used Forklift DC hydraulic pump motor for EV application?

The one in mind is that particular motor from 'Advanced DC Motors':

http://www.trupar.com/advanced-dc-motor-pump-motor-p/av140-01-4003.htm

63238-advanced-dc-140-01-4003-forklift-pump-motor-24vdc-au2500-48kw-d48-frame-114330-3.jpg


It has the following markings:
12 - 24 Volt Dc; RATING - AU2500 4,5KW 20%
Class H

I would be greatful for any feedback. I have the opportunity to buy 2 of these for 500€ (only motors). Should I do it?
What kind of controller would i need to run 1 or 2 of those on a conversion project on Fiat 126?


Regards,
Simon
 
Forklift motors have been used for EV conversion since Methuselah was a lad, but they're not ideal and it depends what you want to do with it. The length alone precludes putting it on a bicycle. They're also heavier and less efficient than modern AC or BLDC motors. On the plus side they're simple, rugged and take short-term over-loading fairly well (till the brushes turn to plasma). Also bear in mind the power rating is based on a 20% duty cycle, whereas most motors are rated for continuous duty.
 
I can only assume, OP, that the attraction is ~4.5kw.

intuitively, u r far more likely to get cutting edge and cheap in mass market ev products, than those for a smaller market and very different app (pump vs transport).

NB the comment here on continuous vs 20% duty cycle ratings, it would seem very doable 3kw+ dd hub motors would be a better hunting ground for you.

the chinese are keen on escooters like very heavy lambrettaS with lead batteries. There is a mass market for strong motors to explore.

plenty of cheap 5kw here, unit buys too:

https://www.alibaba.com/products/F0/5kw_hub_motor/CID100003419----------------------------G--249-353325.html
 
Back
Top