The upper control arm is adjusted by rotation to vary the pivot angle.
I am pointing to the arm here. The heim Joints are right hand thread at one end and left hand thread on the other. This allows length adjustment by simply spinning the arm without disconnecting either end of the arm. This makes adjustment super easy.
My wife and son will be out of town this weekend. So, I we'll be working on the board feverishly. I hope to have the trucks mounted (with steering dampers and related equipment) and the drive units installed. The board should look somewhat complete by this weekend.
This thing is freaking GARGANTUAN! I knew what the overall measurements would be. But, seeing it layed out with all components, it looks so huge!
- IMG_20180214_11672.jpg (84.21 KiB) Viewed 1105 times
Last edited by recumpence
on Feb 15, 2018 10:32 pm, edited 2 times in total.
1% of the world's population can think "Outside the box". The rest are firmly stuck within the box. Where are you?