Goped ESR upgrade - TURNIGY 6374 build

Lightweight / Folding / Portable EVs - seats optional

Re: Goped ESR upgrade - TURNIGY 6374 build

Postby beetbocks » Sun Jan 22, 2017 6:44 am

SarDoX wrote:honestly - I have no clue how to make it charge without opening the board and disconnecting the circuit
2*4s lipos and in series, to charge them I need to plug them to parallel charging board, disconnect stabilizing wires from low voltage meter and also plug them in parallel charging board..
there will be so many extra wires and connectors...


Just a put charging port (deans connector for plus /minus and a 8s parallel cable). Then buy a 8s charger on eBay..
I've done the same on my scoots. Works perfectly. :)

https://endless-sphere.com/forums/viewtopic.php?f=35&t=55997

Or just fit a BMS (battery management system)
Last edited by beetbocks on Sun Jan 22, 2017 12:35 pm, edited 1 time in total. View post history.
beetbocks
100 kW
100 kW
 
Posts: 1010
Joined: Mon Dec 17, 2012 5:45 am

Re: Goped ESR upgrade - TURNIGY 6374 build

Postby Keith_hill » Mon Jan 23, 2017 3:39 pm

Hi!

Have a look at my build here: viewtopic.php?f=35&t=84487 I used a lower KV motor and 12S. I have geared 5:1 and can get 24.3mph reliably. I designed it to do 25mph so i'm pleased.

I'm not sure how you are getting on with gearing and speed but i have overcome a few problems with my build.

All the best!

Keith
User avatar
Keith_hill
10 mW
10 mW
 
Posts: 33
Joined: Sat Oct 29, 2016 10:06 am

Previous

Return to Stand-up E-scooters and E-skateboards

Who is online

Users browsing this forum: No registered users and 6 guests