DIYes i think has his at $99 (pre-order so you'll have to wait a bit to get). Just FYI.Ryuudan wrote:that would be great mccloed, please let us know.
I fried one of my VESCs and need 3 more, and don't have the money to buy them at 200 dollars a piece.
Any update? I am about to buy a few myselfe, but would like to get your opinion firstmccloed wrote:I actually purchased a couple from these guys. Should have them next week. I'll let you know how they are.
before ride look under microscope or lens on the drv legsmccloed wrote:Got the VESC yesterday. First look: Looks cheap. I'm not sure what kind of DRV is normally used but this has the Texas instruments logo on it. They also used vedders capacitor pcb with the three capacitors. The phase wires are only 16 gauge and the power wires are 12 gauge. They heat shrinked it, so I had to cut out the USB and sensor wire connections. I connected it to my computer and a motor and it works fine. They used FW version 2.16 and HW version 4.16. Next step is to ride with it, which I'll try to do this weekend. I'll try to post pics up later today.
and you can try insane settings (my settings- motor 200 amps battery 70 amps absolute max 240)(if i set battery higher ill get abs over current fault sometimes (will try to reprogram to set bigger abs value (now in bldc tool 240 is max that you can type in the window)artteth wrote:okmccloed wrote:looks like the shunts say WSLP2726 .0005 OHMS 1% 1622
for this shunt you need special wrimfare for vesc for 0005 shunt
mine vesc without sad caps toomccloed wrote:So am I ok to use without sad caps as long as I don't run it in FOC? I have caps coming next week.
mccloed wrote:So am I ok to use without sad caps as long as I don't run it in FOC? I have caps coming next week.