Hi guys newbie to the forum here.
I decided to build my own scooter and bought most of the parts online.
I'll be running a dual motor/controller setup.
Everything has arrived and i'm excited to put them together. However i ran into some problems
Firstly the connectors for the throttle is different. Instead of getting new connectors, can i just solder the wires together?
Second, both my motors and controllers have hall sensors on them, but the ones on my motor doesn't have connectors. Again, can i just solder them together?
Third, On my controller, there's a 3-speed gear wire. I'm not sure if the 3-speed gear wire needs to be connected to anything.
And finally the hardest problem i have encountered.
I have a digital voltmeter panel with key ignition (basically my On/Off switch). And on my controllers, there's a single red On/Off wire.
I want to somehow connect the voltmeter panel to my controller to be able to monitor the voltage and also be able to turn On/Off my scooter.
I've tried searching online for help but to no avail.
Hope you guys can help me out here.
Cheers!
P.S. Not sure if i should add pictures but let me know if i need to.
I decided to build my own scooter and bought most of the parts online.
I'll be running a dual motor/controller setup.
Everything has arrived and i'm excited to put them together. However i ran into some problems
Firstly the connectors for the throttle is different. Instead of getting new connectors, can i just solder the wires together?
Second, both my motors and controllers have hall sensors on them, but the ones on my motor doesn't have connectors. Again, can i just solder them together?
Third, On my controller, there's a 3-speed gear wire. I'm not sure if the 3-speed gear wire needs to be connected to anything.
And finally the hardest problem i have encountered.
I have a digital voltmeter panel with key ignition (basically my On/Off switch). And on my controllers, there's a single red On/Off wire.
I want to somehow connect the voltmeter panel to my controller to be able to monitor the voltage and also be able to turn On/Off my scooter.
I've tried searching online for help but to no avail.
Hope you guys can help me out here.
Cheers!
P.S. Not sure if i should add pictures but let me know if i need to.