Hi Guys,
I guess I Need help setting up my new baserunner. I got my wife a cheap chinese fat tire bike back in the summer and it has never had much power. Its a Nakto 36v 300w hub motor
my new standalone baserunner/CA3 arrived yesterday and ran autotune with 23 pole pairs ( a WAG from a youtube video fo a similar bike) and 15v per rev.
It ran autotune fine and seemed to be running great. Set iself to 17.96RPM/V and 23 pole pairs seemed to work. I was jazzed to test out since it seemed to have lots of power
This morning I decided to check everything on the baserunner suite basic page before putting it all back together and I turned down the motorpower to 550w as this is an basically unknown hub motor (300w 36v altho now 48v).
Now I have a fault: Faults2[1]: Current Scaling
So then, I reset the CA3 to defaults but no luck. Still Current Scaling Fault
I guess I Need help setting up my new baserunner. I got my wife a cheap chinese fat tire bike back in the summer and it has never had much power. Its a Nakto 36v 300w hub motor
my new standalone baserunner/CA3 arrived yesterday and ran autotune with 23 pole pairs ( a WAG from a youtube video fo a similar bike) and 15v per rev.
It ran autotune fine and seemed to be running great. Set iself to 17.96RPM/V and 23 pole pairs seemed to work. I was jazzed to test out since it seemed to have lots of power
This morning I decided to check everything on the baserunner suite basic page before putting it all back together and I turned down the motorpower to 550w as this is an basically unknown hub motor (300w 36v altho now 48v).
Now I have a fault: Faults2[1]: Current Scaling
So then, I reset the CA3 to defaults but no luck. Still Current Scaling Fault