Bradz estuff
100 mW
- Joined
- Jun 9, 2019
- Messages
- 36
Hi I've just been setting up new Kelly controller and for some unknown reason it's drawing aprox 6a from battery when motor not moving but it's locked firm in place.
I've obviously screwed something up in the settings.
Any 1 able to send me the default settings so can go back to that and see what's gone wrong?
The controller heats up after only short time so haven't left it on much just need to get it to stop drawing that power so can actually make run
I've obviously screwed something up in the settings.
Any 1 able to send me the default settings so can go back to that and see what's gone wrong?
The controller heats up after only short time so haven't left it on much just need to get it to stop drawing that power so can actually make run