Ozjet
10 W
G'day all,
Two firsts here an ebike build and a bit of posting.
What a great resource we have here, seems like I got on a bit late as I got some bits then started poking about. Not the first to do that I see, anyway were going with what I got with upgrades to come.
48 , 1000 conhis hub
Gm controller
Nice discrete twist throttle.
12/ zippy and turnigy 6s 8000mah to make 3 48v 16a packs
Getting a hitec twin port charger that will charge 200w either side
Also bought after I found they existed a x2 400 dose 400 watts either side, there not released in au though, (wtf)
In the hope of charging a pack, have one charged ready, and one installed.
The motor came in a 700 rim and I ran that in a giant boulder 29er. (That lasted a week then went and bought a susspention job )Nothing was getting even warm really, compared to some of my fast rc models I have clocked flying past at 280 k so I'm quite impressed as to how efficient these things seem to run. I'm hoping that dont change to much as I'm getting the hub laced into a 29er rim. Any gurus got some thoughts there? Might I have to buy something lower kv or rewind it? I have my fingers crossed that its not to bad as am only making space to carry four cells. My first dilemma was how to hold the thing up to work on it.
Two firsts here an ebike build and a bit of posting.
What a great resource we have here, seems like I got on a bit late as I got some bits then started poking about. Not the first to do that I see, anyway were going with what I got with upgrades to come.
48 , 1000 conhis hub
Gm controller
Nice discrete twist throttle.
12/ zippy and turnigy 6s 8000mah to make 3 48v 16a packs
Getting a hitec twin port charger that will charge 200w either side
Also bought after I found they existed a x2 400 dose 400 watts either side, there not released in au though, (wtf)
In the hope of charging a pack, have one charged ready, and one installed.
The motor came in a 700 rim and I ran that in a giant boulder 29er. (That lasted a week then went and bought a susspention job )Nothing was getting even warm really, compared to some of my fast rc models I have clocked flying past at 280 k so I'm quite impressed as to how efficient these things seem to run. I'm hoping that dont change to much as I'm getting the hub laced into a 29er rim. Any gurus got some thoughts there? Might I have to buy something lower kv or rewind it? I have my fingers crossed that its not to bad as am only making space to carry four cells. My first dilemma was how to hold the thing up to work on it.