Its only complete builds direct from LMX which will have the special seal of approval for road use. Mine will just be an anti social dirt bike for up on the hills
Thanks for helping.maitilupas wrote: ↑May 12, 2018 2:44 pmthanks again for a great video Andrew!
a few thoughts ?:
for the seat maybe its better you attach the upper link part a bit further , i think this part is attached with simple wood star( philips) screw into the plastic so it might be better to move them abit more right?
the chain needs one more link for sure! you want about 3 fingers free play in that part before the footpeg
Thanks guys, i really appreciate the help. I was a bit stumped as the user program was different to what i have seen before.maitilupas wrote: ↑May 14, 2018 1:26 amthere is a rev and an auto identify option in the kely user program bellow the smooth settings, be careful when using this , if the motor is running can damage the controller , i ruined one like that...
i guess you can use rev option and use auto identify , and than take the auto identify option out in the next reboot , should be simple as that
which throttle are you using , did you tried 5v instead of 5k?
The fault code was the one you have quoted. I am just using hall sensor throttle, nothing fancy. its all now working fine.maitilupas wrote: ↑May 14, 2018 2:07 pmwhich throttle are you using , did you tried 5v instead of 5k?
Hall throttle is open or short-circuit "When the throttle is repaired, a restart will clear the fault." but i think you red this
I've set Rshunt on the CA to .5000 i assume this is correct for the shunt you supplied me?
yeap ! should be about that! i get 6 with no load! , i do some loading using the disk break, its bad i know..
Great Yes it flickers between 6 and 7 amps.maitilupas wrote: ↑May 15, 2018 2:20 pmyeap ! should be about that! i get 6 with no load! , i do some loading using the disk break, its bad i know..
Thanks for answering. Yes you did send a note, its on the cycle analyst cover, which i completely overlooked!bzhwindtalker wrote: ↑May 16, 2018 1:04 amWe use industrial chain lube, in an aerosol can. It makes a big difference to the noise, but usually the first 100 or so km are a bit noisier than after that due to normal wear of the parts.
I thought for the shunt we had sent a note with the Rshunt value? We sent a 75mv/150A unit so it should be 0.5mohm if I remember right.
Best regards, Adam