maincraft said:Hey brothers.
I need to help, i have VOTOL EM-150SP and QS138 90H.
My question is: "what a settings for MAXIMUM TORQUE from 0 rpm?"
I NEED MAXIMUM POSSIBLE TORQUE FROM START.
Thanks.
maincraft said:Thanks brother. Very appreciate! Now i'm finally understanding about this value.
Yea! I'm using higher reduction ratio 1 x 80 xD but wanna be sure that controller set on for maximum torque perfomance
Cheers
maincraft said:@BareKuda ahahahahah you 100% guessed what i'm doing.
look: https://www.youtube.com/watch?v=cpAyv3x23IA
maincraft said:ahahaha you are right! :lol:
In few next iterations, i'll remove chains and and will attach reductor for each wheel.
But right now it will works with chains.
BareKuda said:maincraft said:ahahaha you are right! :lol:
In few next iterations, i'll remove chains and and will attach reductor for each wheel.
But right now it will works with chains.
Do you have a build thread on this? Im sure many will find this interesting.
maincraft said:BareKuda said:maincraft said:ahahaha you are right! :lol:
In few next iterations, i'll remove chains and and will attach reductor for each wheel.
But right now it will works with chains.
Do you have a build thread on this? Im sure many will find this interesting.
Nop. Brother. Doing it like a hobby project
BareKuda said:maincraft said:BareKuda said:maincraft said:ahahaha you are right! :lol:
In few next iterations, i'll remove chains and and will attach reductor for each wheel.
But right now it will works with chains.
Do you have a build thread on this? Im sure many will find this interesting.
Nop. Brother. Doing it like a hobby project
Add photography to your hobby and post some pictures of your build. Lol
Nice. When it it ready for full scale testing?maincraft said:
For the drivetrain slop settings:
“Starting torque” is the initial torque until drivetrain slack is removed. Normally set to 0
“Combinative torque” is the torque after drivetrain slack is taken up. Normally set to 0
“Rate of rise” is the slope of increasing torque, max is 250.
“Rate of decline” slope of decreasing torque. Set 100 to 250.