Hey guys, wasn't sure where to post this so sorry if it's in the wrong thread.
I'm using the Emus BMS on a new setup. It's a pack of 9 cells using CAN. My problem is that I keep getting an error in the BMS control panel I get an Error - no response in the cell communication field.
Has anyone had any experience setting the Emus BMS up? I've checked the wiki and wired everything according to it, but I still can't read any voltages.
I'm attaching screenshots of the Emus Control Panel. I'm pretty sure it's a setup issue, but I've gone over the documentation and haven't found anything.
If anyone can help I'd be very appreciative.
I'm using the Emus BMS on a new setup. It's a pack of 9 cells using CAN. My problem is that I keep getting an error in the BMS control panel I get an Error - no response in the cell communication field.
Has anyone had any experience setting the Emus BMS up? I've checked the wiki and wired everything according to it, but I still can't read any voltages.
I'm attaching screenshots of the Emus Control Panel. I'm pretty sure it's a setup issue, but I've gone over the documentation and haven't found anything.
If anyone can help I'd be very appreciative.
