Please help

I have bought a new 24f 120volt controller to run my cromotor. I have had the motor a couple years I bought it from zombies a couple years ago. I also bought a controller back then but when I got everything going backthen my brake rotor cut into one of my phase wires and killed my controller. I fixed the wire its been a while but I finally bought a new controller but when I hooked everything up I get nothing I have all the wires going to their corresponding colors and I have my CA hooked up but I am not getting anything when I turn the throttle. I am fairly new to this stuff if someone could please help me figure out whats wrong I would be very grateful I have been waiting 3years to be able to ride my bike.

It's a lot of reading, but this thread should really help out. It has a lot of information for a newbie. Basically, you need to find out the right wire combination since ebike controller and wiring combinations are not standard unless you buy them both from the same source.

https://endless-sphere.com/forums/viewtopic.php?f=16&t=3484