I finally assembled all the parts for my newest e-bike/scooter.
Speed controller, motor, throttle, break, battery. All check.
And not a single thing will plug into the other!
Battery has XT60. Speed controller doesn't, ok easy fix.
Throttle has a tiny little 3 wire connector. Speed controller has a big one. I'm in a rush so going to use soldered on bullet connectors.
Motor wires fit (yeah!) but the hall sensor wires are both female! Ok, again, going to cut them and just use soldered on bullet connectors.
Brake... umm, ok i'll cut and solder bullet connectors.
But not I am up to like 20 bullet connectors on this thing? Can't the chinese just standardize these connections for crying out loud?