Ok thank you!IronMan wrote: ↑Jan 06 2021 11:38pmphase angle should be -60 for hub almost always, nonetheless check diferent values there and see.. if it doesnt run in any angle from -180 to 180.. then change phase and hall wiring, there are 36 combinations...Tom on 101 wrote: ↑Jan 06 2021 7:51pmHey Everyone, I notice that my VOTOL 150 is being seen by the software as an EM100. I have set this to the 150 setting but every time I connect the software sees the 100 preset. I've tried saving the file, loading it but the it always returns to 100 setting, what gives, is there a remedy?
Also once connected to the controller and setting up a motor the motor ran in reverse for a second, but then stopped completely, I can't run it now, no faults are showing in the software and my setting seem fine, got good connection but no throttle or remote throttle, any ideas for this?
Thank you to the people on this thread, its good info for us
You need firmware .bin for em150, if you get it, please post it here.. I only have the .bin for em100
Update: Yup -60 worked and turned the wheel. I had to get the older software to reconnect so its handy to have the 2019 and 2020 version of the EM v3 software. Once I connected and had the old talking to the controller both versions started working, this is very buggy software but it does work and the controller is very powerful. Still big problem though.......
Once the throttle opens up to a point the motor takes off, there's some jitter then I lose throttle command and it just go full on WOT until I hit the breaker!!? Turning the key ignition will not dc the motor and it just keeps going, needless to say this is very dangerous! Any help would be appreciated.Is there a safety for this kind of run-away? Here's the settings