Page 1 of 1

8m HTD pulley Drawing help

Posted: Mar 02 2017 1:09am
by 1000w
I'm in the process of building a mid drive off road bike using a single stage HTD belt.
To get the required reduction I need a 14 tooth drive pulley.
I can't find a 14 tooth 8M HTD pulley to buy so I have been trying to draw the profile on DeltaCad so I can get one laser cut.
However I have discovered this is beyond my skill level, I can't get the tooth profile right.
Is there anyone who is willing and able to draw a simple 2D side view drawing of this type of pulley with 14 teeth?
I'm only requesting this if someone could knock it out quickly and not waste too much of their time on it.
A DXF would be awesome.

Cheers,
Matt.P.

Re: 8m HTD pulley Drawing help

Posted: Mar 02 2017 6:13am
by 1000w
As a sweetener, I have some laser cut torque plates that I can send to whoever helps me out.
They are cut from 6mm steel and there is two sizes, 12mm and 14mm axle with 10mm flats.
Happy to send either or, or both sizes, whatever you wish. How about two of each size?
Cheers.

Image

Re: 8m HTD pulley Drawing help

Posted: Mar 02 2017 6:27am
by xadmx
pm me your email. i have put a 8mm hole in the center but i can put what ever size the want.

Re: 8m HTD pulley Drawing help

Posted: Mar 02 2017 8:30am
by xadmx
email sent. i put a 3d print stl aswell if you can get it printed out you could test the fit before you get them cut.

Re: 8m HTD pulley Drawing help

Posted: Mar 05 2017 7:59am
by 1000w
Thanks for the reply xdmx, unfortunately the DXF does not work???

Re: 8m HTD pulley Drawing help

Posted: Mar 07 2017 4:36pm
by boisrondevens
try Grabcad.com and seach for it...