Page 1 of 1

Derbi GP1 AGNI 95R 3Kw charger, conversion project

Posted: Jun 02 2019 3:52pm
by Buckis
I have plan to sell my scooter conversion (not finished).

Scooter have dead 7 nissan leaf cells (my fault)
EMUS BMS
Navitas max 400A controller (have more like 2 for spares, depends on final price can give away)
Probit programming cable for controller( depends on final price can give away)
Agni 95R electric motor( new shaft, bearings, brushes with holder, it is used not bad condition)
RSP-48 3000, minimum modified to work with BMS (has anderson plug with 5 pins (3 for control)
DC/DC
has 95% of fairings/panels (missing some or broken fixing points around clock)
most panels was fitted new
chasis has V5 for 50CC petrol
wheels powder coated as new, new brakes pads bearings
front suspension new
chain new, sprockets new...
scooter is doing with good battery 60MPH without problem, my plan was low down with controller

at this moment panels and battery is off

custom board computer works but not finished, can be connected to ESP32
board computer have small dc/dc to feed bms (need mods as its drain battery over cold season, can be fitted isulator)
computer works on base mosfets- no relays, has diagnostic leds, i can provide altium files...
to start speed controller needs press brakes and start button- like normal scooter

Located London UK
asking more or less 3500£