Recently I acquired a Govecs 45 km/hr scooter/moped S1.2 with a broken motor. The previous owner tried to upgrade the bearings on the motorshaft but ended up shattering the disk of the quadrature encoder on the back thus destroying the motor....
I primarily bought the scooter for parts/batteries and have no use for the spare controller so I am selling it.
Sine wave controller
It is the 80V version. Produced in 2010.
Peak current 350 A (2 min.)
Boost current 420 A (10 sec.)
Cont. current 140 A (60 min.)
Max operating voltage: 116 VDC (8s lead / 32s LiFePo4 / 28-30s Li-ion/po) - it has been factory programmed for max 116 VDC
Min. operation voltage: 39 VDC
Supports both PMAC motor and AC induction motor control
Needless to say this controller came from a running scooter and has never been opened/altered.
Comes with full original Govecs wiring harness and Sevcon controller connector.
I can send the original Sevcon Gen 4 productmanual and DIY scheme for building the CAN connector to use the Sevcon clearview display (€ 300-350) for adjusting parameters like speed and regen. I also have the clearview programming manual.
This is the same controller as used in Zero electric motorcycles and is very powerfull.
Price: € 350
See 2nd post.
Located in the EU, The Netherlands.
Posting worldwide no problem. I only will send insured and signature required.
PM for quote.