- image.jpg (127.99 KiB) Viewed 2499 times
- image.jpg (206.5 KiB) Viewed 2499 times
- image.jpg (129.75 KiB) Viewed 2499 times
- image.jpg (26.88 KiB) Viewed 2499 times
- image.jpg (185.86 KiB) Viewed 2499 times
Nice.. Impressive if you do your own motors + electronics.DingoMan wrote:Yes the retainer clip does look like his, but mine is for a real Abec11 not a clone. The motor mounts in the wheel hub are completely different and different width. My motor mount hasn't been drilled yet or tapped, It is a split
two bolt system rather than one - i'm just holding the back of the clamp with my finger. I just built these cause my boys wanted some boards and I thought they were too expensive on the market. Having fun doing this I -already have an idea that's quite innovative. I probably pushed to this too early still have to CNC. Thinking about doing my own motors and electronics?
I wanted to switch to 6364 motors too and 15mm belts but no room on the truckonloop wrote:what width belt will you use? looks like 15mm.. so can't have dual rear drive? ... unless you use really small motors i suppose they will fit.
You have a local supplier i'd check with as well. Alien Drive Systems. Richard/Beetbocks was really helpful when i first looked to build my board. Tons of info shared and responsive. Helps (or might) that he's in the UK and local to you.handbaked wrote:Do you sell these parts? Just this eve started looking into a e-board build.