sammyg
10 µW
Hello all,
I have finally got my barfang mid drive. I have also been very busy converting my old lipo battery from 48V to 36V.
Mainly due to the weight factor and the new kit only needs 36V. It was a bit of an effort as I had to get a new bms 12cell to replace the 16cell.
and totally redesign and make the battery case. I will upload a few pics when i can.
After bench testing the barfang the lcd does not turn on, devastated. I get 37V at the on switch for the C965A barfang Lcd but its dead. I dont get the big spark when I connect the battery to the barfang motor, odd. is this normal.
If any one has any ideas on solving this problem please reply as i am now pondering on the idea to hack into the loom and try my CA although i would prefer not to cause i dont want to fry anything as Its a new kit and I have not done any research on adapting or mods yet.
If anyone knows the wiring conversion from the 5 pin barfang lcd to the 6pin CA This would save me the problem of getting another Lcd.
It is also possible that it may not be the Lcd but it seem like the easiest place to start.
I do have the pin config for the barfang. and the pin config of the CA but they are not matching.
barfang pin config controller side is. from R to L. 1 gnd. 2 Txd. 3 P+. 4 Rxd. 5 Pl. CA pin config from CA side is 1 Vbatt. 2gnd. 3shunt-. 4shunt+. 5speed. 6 throttle overide
If only the kit worked. arrrrrr.
Any help would be greatly appreciated.
I have finally got my barfang mid drive. I have also been very busy converting my old lipo battery from 48V to 36V.
Mainly due to the weight factor and the new kit only needs 36V. It was a bit of an effort as I had to get a new bms 12cell to replace the 16cell.
and totally redesign and make the battery case. I will upload a few pics when i can.
After bench testing the barfang the lcd does not turn on, devastated. I get 37V at the on switch for the C965A barfang Lcd but its dead. I dont get the big spark when I connect the battery to the barfang motor, odd. is this normal.
If any one has any ideas on solving this problem please reply as i am now pondering on the idea to hack into the loom and try my CA although i would prefer not to cause i dont want to fry anything as Its a new kit and I have not done any research on adapting or mods yet.
If anyone knows the wiring conversion from the 5 pin barfang lcd to the 6pin CA This would save me the problem of getting another Lcd.
It is also possible that it may not be the Lcd but it seem like the easiest place to start.
I do have the pin config for the barfang. and the pin config of the CA but they are not matching.
barfang pin config controller side is. from R to L. 1 gnd. 2 Txd. 3 P+. 4 Rxd. 5 Pl. CA pin config from CA side is 1 Vbatt. 2gnd. 3shunt-. 4shunt+. 5speed. 6 throttle overide
If only the kit worked. arrrrrr.
Any help would be greatly appreciated.