fevitz
10 W
Ive just respoked a fat tyre wheel for my new motor , it all went very smoothly / no hickups as the calculations of spoke length for the rim and motor at the time were correct when I ordered online
Im still putting this project together , last night I raised the front wheel to test power to battery and LCD connections and during the spinning of the wheel off the ground " it felt like it was out of balance " almost as if it needed weights on the rim like a motor vehicle has . Is there any rule to fix this ,,,or is this normal for such a big rim and tyre ? The wheel "doesn't" wobble ,,, left to right as ive done that correctly , but it does feel like it bobs up and down more than it should
Is there a method for pre stressing the spokes and getting them all evenly tightened to eliminate this ,,,? or is it normal ?
thanks rick
Im still putting this project together , last night I raised the front wheel to test power to battery and LCD connections and during the spinning of the wheel off the ground " it felt like it was out of balance " almost as if it needed weights on the rim like a motor vehicle has . Is there any rule to fix this ,,,or is this normal for such a big rim and tyre ? The wheel "doesn't" wobble ,,, left to right as ive done that correctly , but it does feel like it bobs up and down more than it should
Is there a method for pre stressing the spokes and getting them all evenly tightened to eliminate this ,,,? or is it normal ?
thanks rick