Viewing post history: Re: PAS (Pedal Assist Sensor) installation problems.

This page shows all versions of the post, starting with the most current version.
Viewing post history
This page shows all versions of the post, starting with the most current version.

Current post: Re: PAS (Pedal Assist Sensor) installation problems.

Postby teklektik » Fri May 20, 2016 10:50 pm

Made up a new bracket from a bit of scrap aluminum.
Might be able to recycle the existing steel bracket by folding in the loop on both sides, then forming the mounting U similar to picture.
Not sure about this recycling approach, but just a thought...

80-12_reworkedPasPickup.jpg
80-12_reworkedPasPickup.jpg (13.89 KiB) Viewed 1116 times

80-14_pickupInSitu.jpg
80-14_pickupInSitu.jpg (203.1 KiB) Viewed 1116 times

PasFoldMount.png
Clamp to seat tube...
PasFoldMount.png (8.31 KiB) Viewed 1085 times
Edited by teklektik on Sat May 21, 2016 8:17 am.
Visit Grin Technologies at www.ebikes.ca
Build Thread: 2WD Yuba Mundo V4
User avatar
teklektik
1 GW
1 GW
 
Posts: 3368
Joined: Sat Mar 26, 2011 1:15 pm
Location: CT, USA

Revision 1: Re: PAS (Pedal Assist Sensor) installation problems.

Postby teklektik » Fri May 20, 2016 10:50 pm

Made up a new bracket from a bit of scrap aluminum.
Might be able to recycle the existing steel bracket by folding in the loop on both sides, then forming the mounting U similar to picture.
Not sure about this recycling approach, but just a thought...

80-12_reworkedPasPickup.jpg

80-14_pickupInSitu.jpg

PasFoldMount.png
Edited by teklektik on Fri May 20, 2016 10:54 pm.
Visit Grin Technologies at www.ebikes.ca
Build Thread: 2WD Yuba Mundo V4
User avatar
teklektik
1 GW
1 GW
 
Posts: 3368
Joined: Sat Mar 26, 2011 1:15 pm
Location: CT, USA

Original post: Re: PAS (Pedal Assist Sensor) installation problems.

Postby teklektik » Fri May 20, 2016 10:50 pm

Made up a new bracket from a bit of scrap aluminum.
Might be able to recycle the existing steel bracket by folding in the loop on both sides, then forming the mounting U similar to picture.
Not sure about this recycling approach, but just a thought...

80-12_reworkedPasPickup.jpg

80-14_pickupInSitu.jpg

PasFoldMount.png
Visit Grin Technologies at www.ebikes.ca
Build Thread: 2WD Yuba Mundo V4
User avatar
teklektik
1 GW
1 GW
 
Posts: 3368
Joined: Sat Mar 26, 2011 1:15 pm
Location: CT, USA

Return to E-Bike Technical

Who is online

Users browsing this forum: aschigrunder and 13 guests