Hello everyone. I am looking to buy a cassette removal tool that has already been cut in half. I have a 2016 Radrover with a 750W geared Bafang hub motor and 7-speed Shimano cassette. I just bought a 11-32 Nickel-plated cassette but cannot change it out because of the wire coming out of the axle. I don't want to cut and splice/solder the wire. If anyone has a specail tool for ebikes with hub motors, please PM or reply. I'm willing to pay top dollar just to get my new cassette on. Thanks!
LTB: Split cassette removal tool
- Thread starter walawn
- Start date
Voltron
1 MW
If the motor wire plug is small enough to go thru the cassette, you should be able to dremel out the hole in the tool. I clamped mine in a vice and went at it with the mini drum attachment, only took about ten minutes.
The freewheel removal tool, sold by EM3EV, has a 17.6 mm hole (18 mm if you scraped off the cheap plating) that allows passage of any connectors I know of. It is designed to fit Shimano, and DNP freewheels.
I just found a picture o a 750 watt Bafang I have never seen before. It, like all I am aware of uses a freewheel, not a cassette. However, unlike those I have seen before, the wires come out the freewheel end of the axle, and it has a huge plug!
http://www.aliexpress.com/item-img/BaFang-48V-750W-Brushless-Gear-Hub-Motor/32596521714.html#
I just found a picture o a 750 watt Bafang I have never seen before. It, like all I am aware of uses a freewheel, not a cassette. However, unlike those I have seen before, the wires come out the freewheel end of the axle, and it has a huge plug!
http://www.aliexpress.com/item-img/BaFang-48V-750W-Brushless-Gear-Hub-Motor/32596521714.html#
Voltron
1 MW
It looks like the plug is enlarged to show detail. They use that same plug on a few brands now...super hard to probe the pins in there for troubleshooting
Jon NCal
1 kW
Similar threads
