There is a subject on the Phaserunner but it seems to have reached "saturation".
Looking for insight on connecting a Phaserunner to a MAC10T. If you've done it, please speak up.
Currently driven via a 12 FET Infinity, max current 30A. Over about 10A the audible levels begin to climb. Have a hunch the audible noise may reduce a bit with the Phaserunner.
Would be nice to run sensorless, but not required. I will connect try both ways, but will likely leave the senors connected avoids the passive startup.
About 2400Hz max commutation speed.
Equipped with Thun and CA3.
I have the ASI appliance BacDOOR, and have read the manual. Once I finish the new brackets and cables I'll be giving it a trial.
At one time I measured the resistance and inductance of the MAC 10T, but can't find my notes. If you know them (cell man you watching?).
Thanks in advance.
Looking for insight on connecting a Phaserunner to a MAC10T. If you've done it, please speak up.
Currently driven via a 12 FET Infinity, max current 30A. Over about 10A the audible levels begin to climb. Have a hunch the audible noise may reduce a bit with the Phaserunner.
Would be nice to run sensorless, but not required. I will connect try both ways, but will likely leave the senors connected avoids the passive startup.
About 2400Hz max commutation speed.
Equipped with Thun and CA3.
I have the ASI appliance BacDOOR, and have read the manual. Once I finish the new brackets and cables I'll be giving it a trial.
At one time I measured the resistance and inductance of the MAC 10T, but can't find my notes. If you know them (cell man you watching?).
Thanks in advance.