For phase wires.. i have the first revision of the motor with something like 16 gauge as stock. I cut the phase wires about an inch out the axle and replaced the remainder with 12 gauge wiring to 4mm bullet connectors.
When i showed you folks what this motor was capable of at 6000W in the first pages, i had the 12 gauge wiring installed. The wires were not a heat bottleneck and were adequate for the ~80A i was pushing.
In short, i wouldn't worry too much about the phases. The new thicker ones should be fine even for wheelie popping power levels on a 4T.
When i showed you folks what this motor was capable of at 6000W in the first pages, i had the 12 gauge wiring installed. The wires were not a heat bottleneck and were adequate for the ~80A i was pushing.
In short, i wouldn't worry too much about the phases. The new thicker ones should be fine even for wheelie popping power levels on a 4T.