DarylMc
100 mW
Hi everyone
I just got a used VMoto 110S.
My first electric vehicle project.
Many thanks to Chris Jones for his help so far.
It has no batteries at this stage.
I'm looking at doing 16S of these 75AH cells.
http://www.szwestart.com/ProductView.asp?ID=1086
67.2V max
They are a bit tall but I think I can get creative with the holders or not use holders and make them fit.
Quite a compact setup otherwise and only going to take up about half the battery box.
I would like to get some idea from people who are familiar with the scooter about the weight balance.
Would you put them to the front or to the back?
Because they are so much lighter than the original lead cells I am prepared that I may have to change springs.
I want to get the batteries in the best place before I go doing that.
My previous experience with scooters is that a lot of the weight is on the back wheel so I reckon they should go forward.
Because they are going to be a fairly tight fit I want to decide where they are going before I start.
I just got a used VMoto 110S.
My first electric vehicle project.
Many thanks to Chris Jones for his help so far.
It has no batteries at this stage.
I'm looking at doing 16S of these 75AH cells.
http://www.szwestart.com/ProductView.asp?ID=1086
67.2V max
They are a bit tall but I think I can get creative with the holders or not use holders and make them fit.
Quite a compact setup otherwise and only going to take up about half the battery box.
I would like to get some idea from people who are familiar with the scooter about the weight balance.
Would you put them to the front or to the back?
Because they are so much lighter than the original lead cells I am prepared that I may have to change springs.
I want to get the batteries in the best place before I go doing that.
My previous experience with scooters is that a lot of the weight is on the back wheel so I reckon they should go forward.
Because they are going to be a fairly tight fit I want to decide where they are going before I start.