Hey,
i have an mxus 3000 v1 in my gf fatbike. Buyed this hubbie from a groupbuy.
it has a white cable. Searching the sphere it tells me it is the temp wire.
great.....but how can i setup this with the CA?
the CA has a 2 wire connector. Motor has only 1 wire.
I found in the Groupbuy topic this:
one wire goes through the motors white wire. the other to GND from Hall Sensors.
but i see only bullshit.... (-92° or something above 700°)
Can someone tell me how to wire that Temp Probe using the CA v3 with latest Firmware?
i have an mxus 3000 v1 in my gf fatbike. Buyed this hubbie from a groupbuy.
it has a white cable. Searching the sphere it tells me it is the temp wire.
great.....but how can i setup this with the CA?
the CA has a 2 wire connector. Motor has only 1 wire.
I found in the Groupbuy topic this:
\/ampa said:So have installe motor and have it running. 8)
For all who run the Kelly + CAv3 combo following settings to note.
Odometer
23 Poles
Temperature sensor CAv3
LinearMode
Units 0,67V
Scale 177,2 Deg/V
Kelly Controller
Phase wire
B = Yellow
C = Green
A = Blue
Hall sensors
A = Yellow
C = Green
B = Blue
one wire goes through the motors white wire. the other to GND from Hall Sensors.
but i see only bullshit.... (-92° or something above 700°)
Can someone tell me how to wire that Temp Probe using the CA v3 with latest Firmware?