Ok ill give it a shot.teklektik said:I believe what has happened is that either (1) you flashed the wrong FW file that only loads the app and not does not initialize the EEPROM or (2) have flashed b20 correctly but downloaded an old settings file. When the CA starts up it is totally confused with the earlier EEPROM data on the later FW. The 'Disabled' message is just the mindless ranting of a very confused application - it doesn't mean anything.ebike11 said:teklektik said:Start the download in the Setup Utility - THEN power up the CA - the download will begin before the CA enters the main application.
Do you mean.....
So - you need to reflash using CA3-1b20_firmware.hex using the regular programming cable. The trick here is to start the flash before you turn on the CA. This will get it into download mode before it looks at the confusing EEPROM data. Then you will need to re-enter all your settings from scratch - which sucks - but we're working on that particular PITA...
So i dont use the firmware updating software rather the setup ulility program? After i open the setup utility, it has many settings already preloaded. Does this matter? Thx