mark133
10 W
Hi All I have a new build and have been testing it and it keeps cutting out.
The setup is as follows:
Motor: QS 205 H50 3T V3
Controller: 24 FET
4115 MOSFET 84-132V Mark III High Endurance LYEN Edition Controller
BMS:
Battery: A123 prismatic pouch 20ah, 26s =85.8V (not sure on C rating but believe its high)
All the above are brand new
The bike has a 3 speed switch and on setting 1 and 2 all is fine, when I select position 3 and accelerate past 25mph approx the bike cuts out and I see on the Cycle Analyst (CA) "Low Voltage" and then completely shuts off.
I have tried it with the CA connected and also disconnected but it still cuts out.
Does anyone have any ideas of what i could tweak in the controller software maybe?
TIA
Mark
The setup is as follows:
Motor: QS 205 H50 3T V3
Controller: 24 FET
4115 MOSFET 84-132V Mark III High Endurance LYEN Edition Controller
BMS:
Battery: A123 prismatic pouch 20ah, 26s =85.8V (not sure on C rating but believe its high)
All the above are brand new
The bike has a 3 speed switch and on setting 1 and 2 all is fine, when I select position 3 and accelerate past 25mph approx the bike cuts out and I see on the Cycle Analyst (CA) "Low Voltage" and then completely shuts off.
I have tried it with the CA connected and also disconnected but it still cuts out.
Does anyone have any ideas of what i could tweak in the controller software maybe?
TIA
Mark