72 vott e-bike

Here is a mock-up of the pannels with battery box on the frame

orca-image-1498746982508-jpg_1.jpg

before all the work

20161025_164807.jpg
 
HOLY S**T 600 amp

https://www.aliexpress.com/item/8000W-APT-Sine-Wave-Brush-less-Hub-Motor-Controller-96600/32794155443.html?spm=a2g0s.8937460.0.0.6g00yd
 
I wish mine was 10cm longer like yours. Charge me something close to the original frame price and I'll buy 10-20 of the frames.
 
https://nsmb.com/articles/gary-fisher-e-mtbs

Uphillflow from the original mtb man
 
Hi all quick update rewired the motor and used white heat shrink with black braided over the top :D

Also purchased lights EL panels for sides light slots and chase wire from frame to motor.

will post pictures at end of build sorry needs must and all :idea:


this is the chase wire http://elwirecraft.co.uk/el-products/chasing-el-wire/chasing-el-wire-2-3mm-with-smooth-chasing-motion-effect/

and this is the EL panels http://elwirecraft.co.uk/el-products/el-panel-categories/el-panel-5cm-x-8cm/
 
I'll take some pictures of the chase wire when the battery's turn up :oops:

rsz_20170913_041300.jpg

rsz_20170913_041117.jpg

ps the chase wire will be a video

and here is the braided wires

rsz_20170913_042649.jpg
 
Hi I can't seem to up load the video here so here is a link to the chase wire

https://www.pinkbike.com/u/the12be/channel/lights/

as you can see I can speed it up and slow it down and can also make it go both ways

I will be using transparent heat shrinking to add the chase wire in with the power and phase wire's :D
 
Update I have just ordered a speedometer but will not be able to show pictures until I finish the build :(

But it should look like this :

speedometer.jpg
 
Hi all it's been a long time coming but here is a pic of my bike it's 4 feet tall and 2.10 meters long it's still not finished

rsz_imag0282.jpg


rsz_20180314_215250.jpg
 
Thanks soaresdacosta.
I can't wait to finish it should come togather fast know new 800lb titanium spring on the way and the wiring up should be easy hope my lights look the way I think they will :D
 
here is a update made I rear floating mud guard used 4mm alloy and the front of a top peak xc1 to make it also vinyl wrapped the arm in carbon fiber

20180602_164359.jpeg

can't seem to sort out the one near the spring tried with plastic too make it stronger but no luck :(

sorry also added a 800ib ti spring
 
You must log in or register to reply here.

Similar threads

hexadrome
A bike mechanics cost-effective DIY utility build
Replies
18
Views
2,600
MarkJohnston
M
M
    • Like
London e-bike event
Replies
5
Views
167
Az.
Az.
Josh K.
Josh K. Precision E Bikes Service station, Electric Bike Review
Replies
1
Views
570
Josh K.
Josh K.
A
help for full suspension mountain e-trike
Replies
14
Views
2,385
SlowCo
SlowCo
T
[newbie] e-bike vendors and battery lock-in
Replies
4
Views
956
leffex
L
Back
Top