Got a little work done on the wiring harness of the stock Voloci bike, I took the E brakes off to clean up some wiring, and i'm pretty sure I will not be using any directional in the front so I will cut the bracket down eventually.
I soldered and heat shrunk the wiring so now if I ever need to take the bike apart I cannot disconnect them but I don't really care, and the big bulky connectors always run against the frame and hinder steering at times
Dremmel cut the LED headlight mount so I could fit it in place where the stock one was
Pulled off EBrake wiring and switches
Obviously this will cause my brake lights to not work, I will address this later if I ever do tons of night riding all of a sudden...
decided to wire the horn in for fun
mess of wires
shrunk them down
Put a little tape over them and zip tied the bundle in place so it doesn't hit or rub
Still a little ugly wiring, but its much better