Hey Dave,
I sorted out the throttle esc beep, but still haven’t been able to put too many km’s on.
My trouble is with the temp sensor. I don’t get 5 minutes down the road without it triggering the CA to stop. It reaches a very high temp in a very short time so I’m thinking something is faulty. Even if I put it on a stand and throttle with no load for a few minutes the CA flashes over temp (1188C).
I’m sure I have the CA setting correct as you have outlined in your setup guide. It even reads ambient accurately. Just under power (again even no load) temp climbs fast and it triggers over temp. The water jacket is full and the case is barely warm so I’m sure nothing is hot.
Is there a way to trouble shoot the sensor in the 3220? Any suggestions? Does the “negative”,”positive” make a difference in connecting the two wires to the CA?
Thanks!