Allex
100 MW
No thats not Adaptto. Vasiliy will have a great controller for low cost suitable for lighter bikes.
Yes you can still send your controller in for a repair.
Yes you can still send your controller in for a repair.
Swe said:I have run it some weeks now on my Mini. I had no problem updating. Only thing is that Eco-mode is not working anymore... but I guess that is because I don't have any PAS installed yet (I have ordered).
madin88 said:There are two differnt firmwares. On one the Eco mode works only with PAS (with throttle disabled) and with the other both throttle and PAS works at the same time.
madin88 said:There are two differnt firmwares. On one the Eco mode works only with PAS (with throttle disabled) and with the other both throttle and PAS works at the same time.
notger said:Are those Firmwares availeable in teh most recent Version ?
and where to get them From (in my case for my two Minis)
thanks --> notger
madin88 said:You are looking for the one with PW protection for Normal and Boost mode, and in ECO only PAS schould work?
Allex said:
DasDouble said:I didn´t follow the topic about it so much, but did someone find a way to use a torque sensor for Adaptto instead of the classic old school PAS?
https://www.pedelecforum.de/forum/i...tlager-drehmoment-sensoren.39148/#post-744192stancecoke said:@Hochsitzcola
Willow said:PAS is simple - so 'HALL" type should work..
But it's also shit. If you have an ADAPTTO - throttle control in torque mode is the only way to go. Forget pas.
kdog said:With the wheel off the ground, I was adjusting PWR whilst at WOT & OVS 002. At PWR of over 3.8 I had a
SCARY run away speed increase with instability in rotation. this only happened with the OVS on.
What is this runaway ?
what exactly does PMR do and how does it interact with OVS to do this?
cheers
kdog