Frizzo said:Hi Srn,
With what battery configuration did you go btw?
Hello Frizzo,
I am currently using the Turnigy Heavy Duty 4S 5Ah Lipos. They are rated with 60C (120C burst).
At least for testing they do a good job. Have them in 2S2P now.
Frizzo said:Hi Srn,
With what battery configuration did you go btw?
fabianpusch said:Really strange picture.
I think you are right with the remote input, seems to be 0 or 100%.
What about your cable lengths?
Do you use additional caps.
About settings, try to increase the acceleration time...to 3 or more seconds.
Next use a servo tester as input and check everything again.
how much did it cost?srn said:Hello,
i changed my carbon impeller to a 3D-printed steel impeller. It is really impressive quality and less vibration.
madin88 said:how much did it cost?
toto44 said:Hello SRN
what pitch does your impeller have? Did you balance it?
srn said:Hello,
i changed my carbon impeller to a 3D-printed steel impeller. It is really impressive quality and less vibration.
IMG_3664.jpg
today I will make first measurements of power consumption. Will provide results later.
ropower86 said:How much did it cost you to 3d print in metal?