Kisazul said:
Continue to believe in the nonsense that the manufacturers of the motor of lingbei write. But I want to remove noodles from your ears and show how people are being fooled. Above, it is written that the torque sensor can not stand on the axis, but on the clutch spindle. Well, I bothered to disassemble and this part, which consists of a pair of bearings, a large gear and a clutch response part, which is attached HARDLY by bolts. There is no torque sensor here. I wrote about this above, when I bought this motor and drove it. Also you can see 4 wires going to the pas sensor.
I see you are passionate about this....passionate, confident, and angry? Strong words!
You got this motor early on, correct? - When it was harder to tell about the torque sensing...
Below is the BBS02 PAS:
View attachment 2
notice the location of it... pretty easy to access I suppose...
at least easier then embedding it into the shaft/axle/spindle housing...
such as in the MM28 as shown in your picture below:
now if they copied the BBS design, why place the PAS sensor in such a place?
Lets take a look at the TSDZ2 torque sensor below:
it seems to look alot more like the MM28 sensor, and is mounted in practically the same location...
I also would be interested to see where the wires go (the additional part of the sensor, perhaps) in the MM28 from where we see them...
Also note, you can definitely tell it is a torque sensor on the newer version... I was trying to politely tell you this, but you are really determined this is not a torque sensor...
While you have it open, maybe I can send the new programming for you to update your motor? I will get it when I can, I am laid up with an injury now, but would be happy to provide you with it when I am able.
fantasy2, that goes for you too, I didn't break into the new motor and copy the code, but I will when I am able - and until then I will just get them to send it to me, that shouldn't be a problem now that I think of it, hopefully I won't have to open a motor right now... I have too much going on.
Also, maybe we can compare the old and new code, to get an idea of the torque sensing code, and see if someone can modify/improve that!! eh? now I am really dreaming, hahah