Hi EC,EndlessCadence wrote: ↑Oct 13 2018 6:48amHi kortina, the resets you're talking about aren't related to each other in any way. The EEPROM reset clears your data memory (the firmware configuration). You seem to have issues with the programmer and communication with the device. Is the reset signal (RST) of the programmer properly connected? Basically your device isn't properly programmed right now...kortina wrote: ↑Oct 13 2018 12:54amHi Guys,
Received all of my gear to upgrade my TSDZ2. I have made the cables, flashed the KT-LCD3 OK.
When I attempt to flash my TSDZ2 I get an error:
I have attempted the EEPROM reset:
Code: Select all
> Loading file C:\Users\Michael\Downloads\TSDZ2-v0.13.1.hex in PROGRAM MEMORY area ... < File successfully loaded. File Checksum 0x19D1EE > Programming PROGRAM MEMORY area... Error : Problem while trying to Reset swim and device. Apply a Power On Reset < PROGRAM MEMORY programming completed. > Verifying PROGRAM MEMORY area... Error : Problem while trying to Reset swim and device. Apply a Power On Reset < PROGRAM MEMORY successfully verified.The KT-LCD lights ups, and shows the correct voltage. (52v battery, fully charged showing 57.7).To use the reset to factory defaults feature (it's no longer necessary to program the data memory!):
- Enter configuration menu 6
- Go to submenu 3
- Press the UP button 10 times, a counter on the display will be incremented anytime you do this
- The display will turn off
- Turn it on again and it will reset your configuration to the factory defaults!
The issue that I get is that 0 watts of power are applied to the motor.
Any ideas what I can do to finish this off, and get the bike running again?
Btw ST Visual Programmer 3.4.1 is the correct tool, you don't need ST Link Utility at all.
After double and triple checking my cables, I decided to try another laptop... no more errors!
But... Still the same behaviour.
I have flashed to 0.14 (screen and motor), used menu 6,3 and cleared.
Set my details for 52v setup.
I still have no power.
However, if I start pedaling just after switching on, I get a quick burst for about 0.5sec !?
Any ideas what I should try next?