I have an lmx161 and want to soften the chain and sprocket noise by enlarging both front and rear sprockets. The front 12t sprocket is the noisey one but if I want to keep the same gearing 1:7.8 I will have to enlarge the rear sprocket too.
The rear sprocket is go kart fitment, but sprockets mass produced only my go to 99tooth (as far as i have seen), I will need more. The small sprocket attached to the 14mm lmx motor shaft I want to increase from 12t to say 15t. I cannot find any with the right bore size or tooth count. Closest I’ve found is on the Lighteningrods website which is 15mm bore hole.
Are there any forum members fabricating such needs? Or any company’s preferably in U.K or Europe or even in the U.S that could custom make what I need?
The rear sprocket is go kart fitment, but sprockets mass produced only my go to 99tooth (as far as i have seen), I will need more. The small sprocket attached to the 14mm lmx motor shaft I want to increase from 12t to say 15t. I cannot find any with the right bore size or tooth count. Closest I’ve found is on the Lighteningrods website which is 15mm bore hole.
Are there any forum members fabricating such needs? Or any company’s preferably in U.K or Europe or even in the U.S that could custom make what I need?