wpenner said:
Does anyone have good instructions for installing the temperature sensor on the 8 wire version. I just got my replacement motor and don't want to burn up this one also. Last time I tried to install i think i ended up splicing into the wrong wires as it acted like ebrake was activated when sensor was plugged in. Is there more than one white wire in the controller?
Wiki Pic:
I have the 8 wire version. I spliced into the wires that were attached to the Thr, Gnd and +5v locations in the image below, which was found here - https://github.com/OpenSource-EBike-firmware/TSDZ2_wiki/wiki/How-to-install-motor-temperature-sensor...
I believe that some suppliers of the motor have different coloured wiring, so make sure you use the connection points specified in the image and don't be guided just by the wire colour. For me, the Throttle wire was Orange, the Ground was Black and the +5v was White.
TSDZ2_motor_controller_without_throttle_wires.jpeg
When I installed the temperature sensor, I used this small connector to make it easy to remove at a later time. I purchased a few from here
https://core-electronics.com.au/search/?q=led+strip+pigtail+connector+(3-pin)
and here
https://www.banggood.com/3-Pins-Wire-Connector-Female-Male-Extension-Cable-for-LED-Strip-Light-p-1189494.html?cur_warehouse=CN
14575-led_pigtail_connector_3_pin_-01.jpg
Emma